1, check the cleanliness of the protective lens: not clean, please clean in time; If there is burning point, please replace it in time. (Note that when the protective mirror drawer is taken out, it is necessary to ensure that there is no dust at the scene, and timely use beautiful paper or special plug to effectively seal the protective mirror window)
2, check the copper mouth: copper mouth irregular, obvious scars are recommended to replace in time. Floating head calibration and inspection center are required for each replacement of copper nozzle. Avoid coaxial deviation or air flow not affecting the cutting effect due to this reason.
3. Check whether the ceramic ring is loose: the loosening of the ceramic ring will affect the stability of the cutting operation of the equipment. Please tighten the locking ring of the ceramic ring by hand.
4, check the center: ensure the coaxiality of the laser head, use transparent tape to adjust, try to use a small nozzle (such as 1.0), so more accurate.
5. Capacitor calibration: Start the machine every day to carry out capacitor calibration, and monitor the tool-allocator -F1-2
6. Return to the origin and calibrate the center of Axis B: Start the machine every day to perform the return to the origin action and calibrate the center of axis B
7. Check the air source: check whether the remaining gas of the air source meets the production, and there is no gas leakage in the air route. Check the outlet pressure value of the air storage tank and drain the air storage tank every day before work.
8, clean chuck: after work every day with clean compressed air, clean chuck dust and iron cutting and lubrication and organ cover. As shown in the picture below:
9. Vacuuming pipe: Check whether the vacuuming pipe is damaged or loose every day.
Post time: Mar-02-2023