Symmetrical up – adjustable three – roll coiling machine
Application industry
Sheet metal processing, advertising sign word production, high and low voltage electrical cabinet production, mechanical parts, kitchenware, automobile, mechanical processing, saw blade, electronic parts, glasses industry, spring sheet, circuit board, electric kettle, medical electronics, hardware tools and other industries.
Applied materials
Stainless steel, carbon steel, alloy steel, spring steel, copper plate, aluminum plate, gold, silver, titanium and other metal plates
Product advantage
The main characteristics of the hydraulic three-roll symmetrical coiling machine are: the upper roller of the machine can be lifted vertically, and the vertical lifting hydraulic transmission can be obtained by the hydraulic oil in the hydraulic cylinder acting on the piston rod; The lower roller is a rotary drive, and the lower roller is provided with a supporting roller and can be adjusted.
Specification
Maintenance regulations
1. According to the lubrication diagram of the machine, oil cup lubrication and artificial lubrication points should be oiled as required.
2. Coil the plate according to the parameters specified by the coil machine. The thickness of the coil is 20mm, the maximum length is 2500mm, and the yield limit of the coil material is less than 250Mpa.
3. After the power is switched on, carry out the positive and negative direction of the lower roller and the upward and downward movement of the upper roller, and check that there is no abnormal stuck phenomenon in each movement.
4, strictly in accordance with the plate processing procedures and operation methods for operation, in the upper roller lifting to the limit position, to pay great attention to the safe operation of the equipment.
5. When the main drive stops, the lifting of the upper roll, the tipping reset of the overturned bearing and the cocking of the upper roll can be carried out.
6. In the process of operation, if irregular noise, impact and other abnormal phenomena are found, the machine should be stopped immediately for inspection.
7. In the operation, all personnel should coordinate with each other and follow the command of the person in charge of the roll plate. No command is allowed to start the machine.
8. When rolling the plate, we should pay great attention to the hand being pressed by the plate and rolling together with the plate.
9. When lifting steel plate or drum with the crane, be careful not to collide with the machine. After the end of the winding plate, make sure that the material is finished and the site is clear, and do a good job of equipment maintenance, and turn off the power supply in time.
operating instruction
1, the winding machine must be responsible for management.
2. The operator must be familiar with the structural performance and use method of the winding machine, and can only operate with the consent of the responsible manager.
3, before starting, carefully check whether the safety device is in good condition.
4. During operation, hands and feet are strictly prohibited on rollers, transmission parts and workpieces.
5, after the interruption of work, the clutch should be hit to neutral.
6. There must be a special person to command the collaborative work of many people.
7. Overload is strictly prohibited.
8. The toppling reset of the lifting and turning bearing of the upper roll and the balance of the upper roll shall be carried out after the main drive stops.
9. It is forbidden to pile the workpiece and sundry in the working place, and keep the machine tool and the site clean at all times.
10. After the operation is completed, the power supply should be cut off and the power box should be locked
