One, vibration. Laser cutting machine if vibration, then, it cuts out the product will have serrated. There are two reasons for this. One is the external situation of the machine, such as the machine in the process of cutting, such as the water tank, the opportunity will not be too close, if too close, near the machine tool, when it is running, it will vibrate the machine tool, when the machine is cutting materials, it will produce vibration, will affect the edge of the cutting effect.
Two, machine parallelism. If the machine parallelism is not installed well, when the machine is running, it will not be smooth, then it will be in the process of running, it will also produce jitter, cut out the product is also born in the sawtooth. Three, the lens is not locked. Sometimes, if the lens is not locked, the lens will vibrate when the machine is running, and the light will vibrate when the machine is cutting, so the cutting product effect is not good, and there will be jagged. Four, gear gear seat and other aspects. If the edge of the gear seat is close to the seat, causing skidding and so on, it also causes this to happen. Five, slide wear. There is wear in the slider or a lot of stuff stuffed in the bead of the slider. It wobbles when it runs on the guide rail. So when you cut the material, you have a lot of serrations.
Six, the guide rail is not parallel. The two guide rails in the Y direction are not installed in parallel. When it is running, it will get stuck. When cutting, it will also have serrations. Laser cutting machine if there is a sawtooth when cutting, you can use the hand to hold down the laser head, let it run when it does not let it jitter, if you use the hand to hold down no, it must be the slider problem; If you still have them, check the belt and gear. If a new one does, it must have been installed incorrectly, or its control drive and motor are mismatched.
Post time: Mar-30-2023