The cold water unit of the laser cutting machine must be regularly maintained and maintained, so as to ensure that the machine is in good condition to run, if there is a fault, remember not to handle without authority, should ask professional and technical personnel to repair, shall not disassemble the machine.
The daily maintenance of the cold water unit of the laser cutting machine should pay attention to the following aspects: 1. Regular cleaning of the heat sink, cleaning method is: brush the heat sink carefully, and then blow clean with compressed air, if necessary, water with special air conditioning fin cleaning agent for cleaning and washing.
2. Dust the condenser regularly (same method as above).
3. Check the water level in the water chiller tank regularly. If the water level is too low, pure water or deionized water should be added in time.
4. Check wiring terminals of electrical appliances regularly and remove dust (after power off).
5. Regularly check whether the joints in the waterway system leak, whether the pipeline aging, if there is water leakage phenomenon should be replaced in time.
6. Check the water quality in the water tank of the water chiller regularly. If the water quality of the cooling water becomes worse, turbidity and transparency decreases, all the deteriorated cooling water should be discharged in time and replaced with a new cooling water.
7. Regularly clean the impurities on the filter element, if the filter element is damaged, it should be replaced in time, and the replaced filter element must be the standard filter element required by the manufacturer.
Post time: Mar-08-2023