1. To ensure the safety of personnel and equipment, ensure that the laser system and the water cooler are disconnected from the main power supply, and do not operate on the line 2. Close all inlet and outlet valves of the water cooler. System check Check the power supply
-01=.1. Before powering on the laser cutting device, check all the cable status. Check whether the power supply line is damaged or in poor contact, and check whether the three voltages are balanced 2. Check whether the control signal cable is securely connected. 3. Check whether the input voltage of the main control switch is stable and whether the power terminal is loose. Laser inspection
02 1. Turn on the power to check whether the power supply is abnormal. 2. After the power supply is checked, turn on the power switch to power on the laser. Wait 30 minutes until the laser dehumidifies itself. Water cooler check
1. Confirm again that the inlet and outlet valves are closed. 2. Water tank/water pipe: there is no bending, blockage or damage. Tighten water pipe joints to ensure that they are securely connected. 4. Pour specified amount of water into the water cooler and let it stand for 30 minutes. Turn on the power switch of the water cooler, and keep the power of other devices off. 6. Turn on the inlet and outlet valve of the water cooler slightly, and run the water cooler so that the cooling water circulates back to the water tank from the laser and optical head at a low flow rate, and empty the excess air in the water loop pipe. Mark the water level of the water tank and let it stand for 30 minutes again. Observe whether the water level changes and ensure that there is no leakage in the internal pipeline. When all the above are confirmed, run the water cooler again, open the water valve normally, and wait for the water temperature to reach the set temperature to prepare for the operation of the equipment. Check the air supply system
=04 1. Check that the gas pipe is not damaged, blocked, and has good air tightness 2. Check whether the control valve has been opened, and then manually test whether the outlet air is normal. 3. Customers who use air compressors must ensure that the air compressor runs normally, and the rear filter and cold dry machine work normally. Machine tool inspection
2. Before returning to zero, please ensure that there is no debris on the workbench, dust cover and drag chain to ensure normal return to zero 3. Then confirm whether X, Y, Z manual operation is normal 4. Check whether the nozzle and ceramic ring are locked, check the cleanliness of the protection mirror, manual calibration, coaxial detection 5. Check the lubricating oil circuit and manually fill oil.
1. Check that the water temperature of the water cooler reaches the set temperature 2. Turn on the POWER switch of the laser processing system. After the laser is powered on, the power indicator light of the laser panel will light up. 3. Red light detection method is used to check the lens cleanliness. 4. Coaxial test: judge the coaxiality of the nozzle exit hole and the laser beam according to the following standard. When you have completed the above detection,If the equipment can produce light normally, it can be produced and operated
Post time: Feb-06-2023